IB30 Injection blow molding machine for 5ml~800ml bottles. The machine produces maximal 2,800 pcs bottles per hour. Suitable for most thermoplastic resins such as PE, PP, PS and so on .its products are widely used in medicine packing, the cosmetic packing of making up chemical industry, gifts & toys and so on.
Main features
1. Use proportional variable pump , save 20% power consumption.
2. The clamping framework adopts single-crossbeam and two shores, which enlarges the space of mould, Will be much easier to install mould.
3. Optional tie-bar protection device makes clamping open and close while transfer table rise and drop , so the production efficiency has been improved obviously.
IB30-3S Main Technical Parameters
NO. | Item | Data | NO. | Item | Data |
1 | Dia. Of Screw | 40 mm | 9 | Pressure of comp air | 1.0 Mpa |
2 | Heating power | 9.5 kw | 10 | Consumption of comp air | 0.3 m3/min |
3 | Clamping force 0f injection | 300 KN | 11 | Consumption of water | 3 m3/h |
4 | Clamping force 0f blow | 55 KN | 12 | Overall size L* W* H | 3150*1150*2300 mm |
5 | The template opens distance | 120 mm | 13 | High of bottle | 165 mm |
6 | Cycle without injection | 4 S | 14 | Dia. of bottle | 100 mm |
7 | Mould size L *W | 400*250 mm | 15 | Total power | 24.5 kw |
8 | Main motor power | 15 kw | 16 | Machine weight | 4 T |
Notice: Due to continuous improvement, Specifications are subject to change without prior notice.
Cavity Number of One Mould and Size of bottle . (For Reference)
Diameter (mm) | 25 | 30 | 40 | 50 | 60 | 70 | 75～85 |
Height (mm) | 60 | 80 | 80 | 100 | 120 | 150 | 150 |
Central distance (mm) | 35 | 40 | 50 | 60 | 75 | 85 | 100 |
Cavity quantity | 8 | 7 | 6 | 5 | 4 | 3 | 2 |
NOTE: The production cycle is about 10 seconds for 30ml bottle.
Packing: Sea-Worthy Strong Wooden Cases
PRODUCT FEATURES:
1). Excellent mechanical strength, impact -resisting.
2). Non-cracking bottle mouth and thread are of precise measurement, enabling100% close match with the bottle cap.
3).The weight of the product can be destined.
4).The measurement and thickness of the product can meet the requirement of the design without any deviation.
5).The surface of the bottle mouth and the body is good luster and smoothness.
6).No rough selvedge will occur at the mouth or bottom of the bottle products, which saves the cost of the raw material.
7).On the bottom of the bottle there is no joint seam, and the strength is improved.
8).The joint seam on the bottle body is smooth.
